Professional Polyacrylamide Manufacturer & Global

Our mainly competitors are SNF Group;Solenis;Kemira;ZL Polymers;SINOFLOC;CHINAFLOC,ETC.

We are not only the PAM manufacturer but also professional for M+C+E service,as well as Distributor Comprehensive support and Terminal Market partnership support.

We have been doing PAM since 2003.

LYNXWATER is supplying cationic polyacrylamide powder flocculants with cationic charge ranging from 0-100%.

The handling of polyacrylamide will be simpler than powders as in-line injection could be used with shorter dissolution time and no solubility problems. Powders are very stable during storage in physical setting and formation.

Polyacrylamide as a polymer organic polymer, when dissolved, it will take a certain time to stir for the molecular chain of polyacrylamide to be fully opened. When the water temperature is too low, the dissolution rate of polyacrylamide will slow down. In winter, the mixing time of polyacrylamide is usually extended for half an hour for molecular chain to be fully expanded. If it is available, to heat the water to 20 to 30 degrees is also a good method to speed up dissolving. The water temperature cannot be too high, otherwise the high water temperature will accelerate the degradation of polyacrylamide, and affect the use effect.

LYNXWATER is supplying dry powder flocculants with anionic charge ranging from 0-100%.

LYNXWATER is supplying dry powder flocculants with charge under 5%.

Polyacrylamide is most commonly used as flocculants, abbreviated as PAM. Flocculants is the linear polymer. Besides polyacrylamide solid aluminum sulfate, liquid aluminum sulfate, alum, polyaluminum chloride, ferric chloride, ferrous sulfates are also used as flocculants.

First, select a well-ventilated and dry warehouse, and to reduce the time of sunlight as the sun exposure will make polyacrylamide molecular weight degradation. Moisturizing polyacrylamide is easily to agglomerate and hard to dissolve as an aqueous solution during dissolution. If in a solution case, after the polyacrylamide dissolved in aqueous solution not used up, the remaining polyacrylamide solution should be filled with a lid seal to prevent dust from entering. The storage time of polyacrylamide is 48 hours. The solution becomes thinner when the polyacrylamide solution is stored for an extended period of time.